Mr Stromberg Carbs - Quality re-manufactured / rebuilt carbs
and setups.  Specializing in Stromberg 97 / 48 / 81's
Mr Stromberg

Phone: 913-244-0112
Linkage Parts
============================================================================
============================================================================
============================================================================
============================================================================
Swivel with set screw
MCS250F5
$9.00
Spherical End Single - 1/4-28, steel ball bearing
MCMSF-4heim
$13.00
Short aluminum cast carb arm
ELSA
$7.50
Multi-hole arm with set scews
MSMHA
$17.00
1/4 Aluminum Collar with set screw
CQTR
$4.00
============================================================================
============================================================================
Ball Joint Female End to feed throttle rod with 1/4-28 thread, snap-on ball joint
MCMDB-4
$14.00
Male/Female Wire Stop Ball Joint for throttle linkage, adjustable, with set screw and jam nut
MSTBJ
$27.00
============================================================================
Throttle return bracket and spring for Stromberg multi carb setups
TRBAS
$10.00
============================================================================
Wire Stop Stand alone
MCWS088
$6.00
============================================================================
============================================================================
Double Spherical End 1/4-28 Left and Right hand threads
$16.00
QUICK RELEASE CABLE AND LINKAGE END - 1/4"-28 RH Thread - These steel ends are pefect for throttle cable or linkage that needs to be quick release. They have the same thread on the stud as they do in the body. 
$12.00
THROTTLE ROD SLEEVE, 1/4" HOLE
$6.00
Stainless Steel Back Bar Brackets (pair) for Stromberg 97, 48, 81's. Secures with existing air horn screws.
$23.00
Throttle Shaft Extension - Use these to extend the throttle shaft out past the carburetor next to it on manifolds where the carbs are staggered close together like Man-A-Fre, McGurk and Weiand 6/71-6. Works on all Stromberg and Holley 94's. Attaches with 2 set screws
$12.50
============================================================================
Stainless Steel Carburetor Throttle Arm - This super nice Stainless Steel throttle arm is 1-7/8" long and an awesome 5/16" thick! Even the set screw is Stainless Steel! Fits a .274 shaft (or can be drilled out for oversize throttle shaft) for use on Stromberg, Holley 94 and Edelbrock 94 carbs. Made in USA.
$10.00
============================================================================
============================================================================
Back Bar Assembly for 4x2 side by side or 6x2 setups. Includes 2 - Stainless Steel Brackets, 2 - 1/4id Heims, 2 - Stainless Steel Screws, 2 - Stainless Steel washers. Add your 1/4 rod our multi-hole or stainless steel arms to control both banks of carbs. (rod and carbs not included)
$55.00