Mr Stromberg Carbs - Quality re-manufactured / rebuilt carbs
and setups.  Specializing in Stromberg 97 / 48 / 81's
Mr Stromberg

Phone: 913-244-0112
4x2 Linkage
4x2 log style linkage, for use with log style manifolds. No progression. All four carbs work together.
$169.99
4x2 Inline Straight Linkage Ball Bearing (specify carb to carb center when ordering)
MS4x2SBB
$64.00
4x2 Straight Inline Linkage (specify carb to carb centers when ordering)
MS4x2SS
$48.00
==============================================================
===============================================================
===============================================================
Check out the following hard to find items to finish off your linkage installation
============================================================================
Ball Joint Female End to feed throttle rod with 1/4-28 thread, snap-on ball joint
MCMDB-4
$14.00
Male/Female Wire Stop Ball Joint for throttle linkage, adjustable, with set screw and jam nut
MSTBJ
$27.00
============================================================================
Throttle return bracket and spring for Stromberg multi carb setups
TRBAS
$10.00
============================================================================
Wire Stop Stand alone
MCWS088
$6.00
Stainless Steel Back Bar Brackets (pair) for Stromberg 97, 48, 81's. Secures with existing air horn screws.
$23.00
Throttle Shaft Extension - Use these to extend the throttle shaft out past the carburetor next to it on manifolds where the carbs are staggered close together like Man-A-Fre, McGurk and Weiand 6/71-6. Works on all Stromberg and Holley 94's. Attaches with 2 set screws
$12.50
Stainless Steel Carburetor Throttle Arm - This super nice Stainless Steel throttle arm is 1-7/8" long and an awesome 5/16" thick! Even the set screw is Stainless Steel! Fits a .274 shaft (or can be drilled out for oversize throttle shaft) for use on Stromberg, Holley 94 and Edelbrock 94 carbs. Made in USA.
$10.00
============================================================================
============================================================================
============================================================================
Back Bar Assembly for 4x2 side by side or 6x2 setups. Includes 2 - Stainless Steel Brackets, 2 - 1/4id Heims, 2 - Stainless Steel Screws, 2 - Stainless Steel washers. Add your 1/4 rod our multi-hole or stainless steel arms to control both banks of carbs. (rod and carbs not included)
$55.00
============================================================================